292 498 manuals 489 133 models 3 159 brands. Computer Equipment 99617. The AT40M – JEMS comes standard with a single-operator, 400 pound capacity platform with an 800 pound capacity material handling jib. This unit has a 45-foot working height and 30-foot side reach with a 180 degree platform rotator. Try it with the new composite ISO-Boom option to allow the unit’s second stage to be fully retracted while. Altech Ads Megapixel User Manual Age Of Empires 4 Utorrent For Mac Summon Night Swordcraft Story 3 Usa Gba Crack 30 Day Trial Periods Programs Jal Aadat Album 320kbps Download Software Banking Law And Practice By P Varshney Pdf Malwarebytes AntiMalware Premium V2.0.2.1012 Keygen.
Articulating Telescopic Aerial Device
The AT40M – JEMS comes standard with a single-operator, 400 pound capacity platform with an 800 pound capacity material handling jib. This unit has a 45-foot working height and 30-foot side reach with a 180 degree platform rotator. Try it with the new composite ISO-Boom option to allow the unit’s second stage to be fully retracted while maintaining dielectric integrity and meeting OSHA guidelines for minimum approach distances.
| General Specifications: |
|---|
| Ground to Bottom of Platform*: | 40 ft (12.2 m) |
| Maximum Side Reach: | 30.8 ft (9.4 m) |
| Boom Articulation (Lower Boom): | -25 to 75° |
| Rotation: | Continuous |
| Download Spec Sheet |
| Standard Features: |
|---|
- Altec Arm Jib
- Fiberglass Upper Boom and Lower Boom Insulator
- Insulating, ANSI Category C, 46KV and Below
- Compensated Articulating Arm
- Continuous Rotation
- Hydraulic Boom Extension
- Hydraulic Platform Rotation and Tilt
- Full Pressure, Open Center Hydraulic System
- Outrigger Motion Alarm and Outrigger Interlocks
- Platform Access From Ground
- Emergency Stop Valves at All Upper and Lower Control Stations
- Platform 24 x 30 x 42 in Nominal
- Tool Circuit at Platform
- Extension Dependent Load Chart
- Jib Capacity Up To 800 lbs (362.9 kg)
|
| Optional Features: |
|---|
- 2-Man Platform with 180° Rotation and 600 lb (272.2 kg) Platform Capacity – Material Handling is Not Available in This Configuration
- Secondary Stowage System
- Engine Start /Stop
- Second Tool Circuit at Platform
- Tool Circuit Below Rotation
- Manual Throttle
- Jib Adapter
- Phase Lifting Jib Attachment
- Platform Covers
|
| Recommended Features: |
|---|
- Fall Protection System
- Wheel Chocks
- Outrigger Pads
|
*Based on chassis frame height of 40 inches (1016 mm)
Altec Aerial Devices meet or exceed all applicable ANSI Standards as of the date of manufacture. Altec reserves the right to improve models and change specifications without notice or obligation. Altec provides custom options in countries throughout the world. Please contact Altec Worldwide for the options available in your country.
Download Operation & user’s manual of Altec Lansing 641 Speaker System for Free or View it Online on All-Guides.com.
Brand: Altec Lansing
Category: Speaker System
Type: Operation & user’s manual for Altec Lansing 641
Pages: 24 (0.57 Mb)
Find more troubleshooting tips in the FAQs located in the
Customer Support area of our web site: www.alteclansing.com.com.
Q.When connected to my computer sound card, should I use the
Windows volume control to adjust the volume of my speakers?
A. No. Adjust the Windows controls to about center as a starting point
and then use the speaker controller to adjust volume control. If the
volume is turned too high on the sound card, it can distort the sound.
Q. One and sometimes both of my speakers do not work.
A. Check the input cable from speaker to the audio source and make
sure that it is connected to the line-out jack, which is the un-amplified
source. Make sure all the cables are plugged in correctly and have a
good connection. Still not working? Then try unplugging the cable from
the back of the computer, and insert the stereo plug into the headphone
jack of an alternate source (e.g., Walkman, Discman or FM radio) and
play music. If the speakers work, you may need to adjust your volume
and balance controls in your audio source, or Windows, if connected to
Q. My speakers give off a crackling sound (or static, or other noise).
A.Check all cables and make sure that they are connected to line-out
or audio-out jack on your sound card or other audio source, and NOT
speaker-out. If your audio source is your computer, check the volume
control in Windows: make sure that it is not set more than halfway.
Setting this level too high can cause sound distortion. If this does not
stop the noise, unplug the cable from the audio source and use an
alternate source (e.g., Walkman, Discman or FM radio) by plugging the
stereo cable into the headphone jack. If the noise goes away, you may
Q. What can cause radio feedback?
A. If you are living near a radio tower you could have interference
caused by radio frequency. Try moving your speakers to see if the
interference goes away; if not, you may be able to purchase a stereo
cable from your local retailer that has a higher percentage of shielding.
A. Yes, as long as your TV or Stereo has an unamplified source which
is line-out (check your TV or Stereo owners manual). These speakers
may be used with any audio device that has a stereo headphone jack.
You may also need a cable that has RCA jacks on one end and a 1/8
Altech Ads Megapixel User Manual Free
inch stereo connector at the other end (these may be purchased at most
Q. I have very little bass coming from my Subwoofer. How do I increase
A.Adjust the BASS control through your audio sound source
(computer sound card control, CD player control, etc.). Check to make
sure that all of your cables are hooked up correctly and are making a
Q. I have a low hum coming from my Subwoofer. Is this normal?
A. Yes. The AC in your house is at 60 cycles per second, which is
within the audio frequency of your subwoofer. Some low hum is natural
and can be detected when your speaker system is powered on without
source audio playing, or when volume is set at an extremely low level.
Q. I have a loud hum coming from my Subwoofer. What should I do?
A. Move the power cord from the power surge protector (if applicable)
and plug directly into an AC wall outlet. Move your cables and check to
see that they are making a good connection. If you disconnect your
Altech Ads Megapixel User Manual
stereo cable from the audio source and the loud hum goes away, then
you may need to adjust the volume control in your audio source as you
may be overdriving the volume settings on your speaker system. If you
are using your 641 speakers with your computer system, just click on
the speaker icon located next to the digital clock to the lower right of
your Windows 9X or 2000 screen and adjust the volume.
Q. When I put my Subwoofer on my desk my monitor distorts. Why?
A. The Subwoofer is not magnetically shielded, and this can cause
distortion if it is less than 3 feet from your monitor.
Q. The DIN connector from the controller has multiple pins on one end,
and when trying to attach this cable I noticed that some of the pins are
bent, so I am not able to insert the cable into Subwoofer. What should I
Altech Ads Megapixel User Manual Pdf
A.Try to gently straighten the pins with tweezers or very small pliers. If
this does not work, then contact the Altec Lansing Consumer Support
Related Products for Altec Lansing 641
Altech Ads Megapixel User Manual Online
Related Manuals for Altec Lansing 641
Altech Ads Megapixel User Manual Download
Altec Lansing 641: Frequently viewed Manuals